Support and General Use > Hardware

Fuze and Griffin Dock line out

<< < (9/14) > >>

funman:
Currently we don't read on DBOP because all the buttons can be read on GPIO but it should work easily.

Unfortunately I don't have my fuzev2 to test.

ccfreak2k can you make your own build and try patches?

EDIT: when you plug the dock, is the charging icon present?

ccfreak2k:

--- Quote from: funman on September 19, 2010, 02:56:57 AM ---ccfreak2k can you make your own build and try patches?

--- End quote ---
I don't have the toolchain installed on any of my computers. Will the VMWare image work?

EDIT: Tried VMWare image, didn't work, presumably because of the switch to EABI that happened at some point.


--- Quote from: funman on September 19, 2010, 02:56:57 AM ---EDIT: when you plug the dock, is the charging icon present?

--- End quote ---
Charge icon does appear when plugged in.

saratoga:

--- Quote from: ccfreak2k on September 19, 2010, 03:42:17 AM ---EDIT: Tried VMWare image, didn't work, presumably because of the switch to EABI that happened at some point.

--- End quote ---

If you run 'sudo tools/rockboxdev.sh' from the root of your source code check out it should upgrade your image to EABI.

ccfreak2k:
Looks like the virtual machine ran out of space while compiling the toolchain, so I'm going to just use my Slackware box for compiles. Set up a seperate user with its own copy of the toolchain and made what seems to be a working build, so I should be all set.

hynpin:
Found out that:

LOD for FUZE has got jumper between pin #7 and #22.
Line-out is activated by 3V on pin #7.

Hope this will help  ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page