Support and General Use > Hardware
Fuze and Griffin Dock line out
saratoga:
--- Quote from: sanmigel on May 05, 2010, 03:57:58 AM ---Hi! Does any progress in line out on Fuze rockbox?
--- End quote ---
I'm sure if theres progress, someone will mention it.
orbidia:
I could definately use line out from the fuze for a portable setup with an external amp and a diy line out cable.
It sounds like gglul figured it out and it works on the fuze v1 at least. I guess gglul's "patch 2" is the one to use.
Is this difficult to post to flyspray and get this in one of the builds? Sounds like the code is done and just waiting to be added...
OldOne:
There is a patch on flyspray to enable for E200v2 as well as Fuze v1. Work is being done on the Fuze v2. #11367
Link Below
http://www.rockbox.org/tracker/task/11367?project=1&type=4&order=dateopened&sort=desc
mc2739:
Line out for the e200v2 is enabled as of r27162. This should also work for the Fuzev1, but has not been tested.
Be sure to connect the dock after booting Rockbox. Connecting the dock with power off will boot into the OF.
For the c200v2 and Fuzev2 we still need to determine how to detect when the dock is connected.
Avalon:
I have tested on a Fuze V1 and it works!
Many thanks to the developers. This is a very useful feature.
I have found one problem which may be a setting I am not aware of. My Fuze powers down while docked after about 10 minutes. I have changed the idle timeout to off with no change. Does anyone know why this is happening?
A couple of observations:
1. As indicated, the Fuze must be in RockBox mode before connecting.
2. When the Fuze is connected it displays the "USB Keyboard Mode: Multimedia" message, pauses the current track and reverts to the main menu. You must select "Resume Playback" to continue with the current track.
3. When connected to the dock, the Fuze appears to provide the true line out since there is no volume control at the Fuze. I checked this by disconnecting the playing Fuze from the dock and connecting it to the dock output cable. To get the same volume level, the Fuze volume had to be set to the 6dB maximum level.
4. I could not check to see if the headphone output is enabled when connected to the dock because I have to remove the headphones to connect to the dock. However, this is not a consideration for me since the dock keeps the Fuze fully charged.
Thks again!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version