Hi, I am running into a brick wall trying to install Rockbox on my Sansa Fuze (V1 type, 4GB) which I just received today.
I have flashed it to firmware version 01.02.26 which applied successfully (it runs OK under the native firmware), but when I try to run rbutilqt.exe (version 1.2.2) it does not show me the Fuze under the Sansa tree, and, when I tell it to try to autodetect, it hangs, then my screen goes pale, and then it crashes, with no message (other than a Windows message telling me that it crashed).
I am logged in as an administrator, and also tried explicitly launching the program via "run as administrator" but the results are the same.
The Fuze is in MSC mode.
I have successfully installed Rockbox on my Sansa e260 V1 using an earlier version of the RockboxUtility, and updated it to version 3.3 using the current version of rbutilqt.exe without any problems, but I am up against a brick wall with my Fuze.
Can anyone give me any suggestions?
Thanks in advance!