Rockbox Development > Starting Development and Compiling

[Solved] New USB-enabled bootloader not appearing to work on e200

<< < (2/2)

saratoga:
I just tried this on my Sansa using the latest SVN:


--- Code: ---mike@biosgroup-desktop:~/rockbox/ams/rbutil/sansapatcher$ sudo ./sansapatcher  -bl ../../e200v1bl/bootloader.bin
sansapatcher v0.8 with v6.0 bootloaders - (C) Dave Chapman 2006-2007
This is free software; see the source for copying conditions.  There is NO
warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.

[INFO] Scanning disk devices...
[INFO] e200 found - /dev/sdc
[INFO] Reading partition table from /dev/sdc
[INFO] Sector size is 512 bytes
[INFO] Part    Start Sector    End Sector   Size (MB)   Type
[INFO]    0             600      15667199      7649.7   W95 FAT32 (0x0b)
[INFO]    1        15667200      15708159        20.0   OS/2 hidden C: drive (0x84)
[WARN] PPBL installation will overwrite your bootloader. This will lead to a
       Sansa that won't boot if the bootloader file is invalid. Only continue if
       you're sure you know what you're doing.
       Continue (y/n)? y
[INFO] PPBL updated successfully.
mike@biosgroup-desktop:~/rockbox/ams/rbutil/sansapatcher$

--- End code ---

Everything works as expected.  Are you sure you didn't just accidentally flash an old bootloader.bin file?

bascule:
Well, you're correct. I bit the bullet and disconnected and booted and it's fine, including the direct USB mode from power-off. I suspect deleting the bootloader was required before re-loading.

It all just looked as though nothing had happened. And still, the sansapatcher -l lists only one Image, which was the bit that worried me...

Anyway, thanks as always for all the help, here. Much appreciated.

Navigation

[0] Message Index

[*] Previous page