Support and General Use > Plugins/Viewers
How do I edit the Gigabeat Flashwriter to accept my checksum? Is it safe?
blackbird:
ok, my installation does not have a plugins folder in the apps. How do I prepare the flashwriter? Do I need to compile/change filename, or do I save it as a .rock? I tried saving as .rock, and it said it was unsupported.
saratoga:
--- Quote from: blackbird on July 23, 2009, 07:34:12 PM ---ok, my installation does not have a plugins folder in the apps.
--- End quote ---
Either you didn't check out the source code properly, or you're not looking at the rockbox source code.
--- Quote from: blackbird on July 23, 2009, 07:34:12 PM ---How do I prepare the flashwriter? Do I need to compile/change filename, or do I save it as a .rock? I tried saving as .rock, and it said it was unsupported.
--- End quote ---
Did you read the replies the first time you asked this question? The answer hasn't changed ;)
blackbird:
oo, so there is the problem. I wasn't looking at the source code. So I saved the .c file to the plugins folder, but I don't know how to edit the sources folder. (I'm sorry for being so irritating). It would be much easier if I had my ubuntu desktop available right now. Im compiling from windows.
saratoga:
--- Quote from: blackbird on July 23, 2009, 07:56:38 PM --- So I saved the .c file to the plugins folder, but I don't know how to edit the sources folder.
--- End quote ---
Its a file, not a folder, and just edit it with any texteditor. You'll need to add a line for you new .c file. Should be pretty obvious once you look at the file.
blackbird:
Ok, so I put it under "sources common to all platforms", and I followed the instructions of the "How to compile" FAQ. However, this is what I get. :
Platform set to gigabeatf
Build (N)ormal, (A)dvanced, (S)imulator, (B)ootloader, (M)anual: (Defaults to N)
n
Normal build selected
Using source code root directory: /home/kent/rockbox/rockbox
../tools/configure: 2372: arm-elf-gcc: not found
../tools/configure: 2380: arm-elf-ld: not found
WARNING: The compiler you must use (arm-elf-gcc) is not in your path!
WARNING: this may cause your build to fail since we cannot do the
WARNING: checks we want now.
Using arm-elf-ld
Created Makefile
How do I get the elf-gcc file?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version