Support and General Use > User Interface and Voice

make morse code default?

(1/2) > >>

animatorgeek:
Is there some way to make morse code the default text entry method on the h1x0?  If it isn't possible to change it with a setup file or something (which it seems like it should), would it be possible to change it without too much trouble in the source code?

Chronon:
Why?  Because the key combination to enter Morse code mode is too troublesome?

animatorgeek:
Basically, yes.  It would be nice to not have to think about it.  It seems like something that should appropriately be a setting in the menus anyway.  I would think that each user would almost always want one or the other, and rarely switch between the two.  Why, then, require the user to switch every time if they don't like the default?

keenerd:
It would be more useful if it were enabled on more targets.  I was a little surprised when I switched from an H10 to a sansa c200, and found my beloved Morse code entry gone.

I do agree with you that it should be a configurable option.  It is also fantastically nice to type stuff without having to look at the screen or juggle more than two buttons.  I expect I may be doing a lot more typing now with the Lua support.

animatorgeek:
I'm actually delving into the code now to try and make a morse code setting in the menus.  I think I found how I could make morse code default in a custom build, but I figured why not go all the way and make it user configurable?

Navigation

[0] Message Index

[#] Next page