Support and General Use > Audio Playback, Database and Playlists

Volume delay?

(1/3) > >>

sanarell:
Hi all.  Using a Sansa e270.  When I adjust the volume, either
up or down, there is a delay of about 2 or 3 seconds then a fade
up or down to the desired volume level.  Most of the time the
level is not desired and is too loud or too soft, since the reaction
is not real time.  Is there any way to disable this behavior?  Thanks.

Multiplex:
That's strange - exactly how are you adjusting the volume?

AlexP:
That's very odd - I haven't noticed that myself.  What version of Rockbox?

sanarell:
It's version 3.2-090323.

I'm spinning the blue ring to turn the volume up and down.
I'll give it a spin or 2 and the volume just stays the same,
then 2 or 3 seconds later it fades up or down, usually to
a level that's too high or low because I can't tell where it
is while I'm spinning the ring.

BTW, when I boot into the Sandisk firmware the volume
control behaves normally.  It responds immediately when
I spin the blue ring.

I have a 2GB micro SD card in it if it makes a difference.

Thanks.

saratoga:
What happens if you remove the config file out of your .rockbox folder (resetting the settings)?

Navigation

[0] Message Index

[#] Next page