Welcome to the Rockbox Technical Forums!
I can't believe I'm still subscribed to this thread almost two years later...This "feature" really annoys me too. What device do you want this compiled for? I'll post the .zip.
3. You may copy and distribute the Program (or a work based on it, under Section 2) in object code or executable form under the terms of Sections 1 and 2 above provided that you also do one of the following: a) Accompany it with the complete corresponding machine-readable source code, which must be distributed under the terms of Sections 1 and 2 above on a medium customarily used for software interchange;
I have a Sansa Clip+ as well! I guess this gives me an excuse to update.http://www.mediafire.com/?01jxqu22u9qo18m
Although I've never manually installed before, I just used the Rockbox Utility. I'm trying to make sense of http://www.rockbox.org/wiki/SansaAMS#Installation but do I need to do all these steps if I'm using your .zip and if I already have a successful Rockbox installation on the Clip+?
Do you have the source code for that build somehwere?
Quote from: gevaerts on November 19, 2012, 05:43:27 AMDo you have the source code for that build somehwere?I do. However, it's quite large (329 MB). I can compile it for a specific device if you'd like.
I do. However, it's quite large (329 MB). I can compile it for a specific device if you'd like.
Just unzip it to the root of your device.
That's not the point. This is a matter of GPL compliance. You shouldn't distribute builds without matching source (unless you go for the written offer valid for at least three years route)
For GPLv2, the source code offer is fulfilled only with physical media.
I guess that's out of the question. See my original post.
Page created in 0.056 seconds with 21 queries.