Rockbox General > Rockbox General Discussion

Capacity of sansa e250

<< < (2/3) > >>

Chronon:
The current builds have USB mode enabled.  The release version does not.  If you want Rockbox to boot when you insert a USB cable while the player is turned off then you need to install an updated bootloader.

edit: I don't know where that previous flyspray task came from.  Follow the link in the next post.

ThaCrip:

--- Quote from: sirdan on April 02, 2009, 04:55:30 PM ---Sorry for changing subject but dont want make new topic. Recently usb charging was added to sansas. Is rockbox suppose to start when sansa plugged to usb port? Now just bootloader(?) start and then OF.

--- End quote ---

http://www.rockbox.org/tracker/task/9955 ... using that will make it so Rockbox boots all the time when powering on player by connecting it to the USB port ;) (you can still force it to boot original firmware by pressing and holding the left button on the dpad when powering it on.

'sansapatcher.exe -a PP5022.mi4' (without the ') will install the bootloader to your Sansa e200 series player.

sqgl:

--- Quote from: ThaCrip on April 03, 2009, 12:37:48 AM ---http://www.rockbox.org/tracker/task/9955 ... using that will make it so Rockbox boots all the time when powering on player by connecting it to the USB port ;)
...
'sansapatcher.exe -a PP5022.mi4' (without the ') will install the bootloader to your Sansa e200 series player.

--- End quote ---

Thanks for that tip. I went to that URL and downloaded bootloaders.zip but the c200 folder only contains the file firmware.mi4 rather than PP5022.mi4

Can I presume they have changed the name of the file since you posted?
I may as well await your reply (please) before proceeding.

For the benefit of others reading this, I include the following quote from http://download.rockbox.org/manual/rockbox-sansae200/rockbox-buildch2.html
   1.  Download sansapatcher.exe from http://download.rockbox.org/bootloader/sandisk-sansa/sansapatcher/win32/sansapatcher.exe  and run it whilst logged in with an administrator account.
   2. If all has gone well, you should see some information displayed about your e200 and e200R Series and a message asking you if you wish to install the Rockbox bootloader. Press i followed by ENTER, and sansapatcher will now install the bootloader. After a short time you should see the message “[INFO] Bootloader installed successfully.” Press ENTER again to exit sansapatcher.

yapper:

--- Quote from: sqgl on May 17, 2009, 04:40:42 AM ---Thanks for that tip. I went to that URL and downloaded bootloaders.zip but the c200 folder only contains the file firmware.mi4 rather than PP5022.mi4
Can I presume they have changed the name of the file since you posted?
I may as well await your reply (please) before proceeding.

--- End quote ---

The c200 uses firmware.mi4

The e200 uses PP5022.mi4

BruceHP:
I read the Patch page and it looks like , if you are using an e200 with the Start Screen setting set to "Resume Playback" , that this new Bootloader isn't working properly.

Did I miss something?

BTW, The Sansa comes with a bunch of crappy music that is loaded on the MTP side, did you delete these files?

Navigation

[0] Message Index

[#] Next page

[*] Previous page