Installation / Removal > Sandisk - Installation/Removal

USB connect while holding SELECT on c240 doesn't enter Rockbox in 3.1 or builds.

<< < (2/3) > >>

gevaerts:

--- Quote from: AJ Schroeder on February 11, 2009, 01:40:06 PM ---I read it, and I went back and read the manual for my player (e280R) and while I am using an E series player and not a C series, the documenation is the same.

--- End quote ---


--- Quote ---****  UPDATE  ****

I discovered that the issue referenced below is solved by attempting the connect while already in Rockbox.  A cold boot-up does not work as I interpreted it in the manual.  Now that I understand, all is good.

*******************************************************

--- End quote ---

boot rockbox, then connect, as clearly stated in the original post of this thread

AJ Schroeder:

--- Quote ---boot rockbox, then connect, as clearly stated in the original post of this thread
--- End quote ---

Sigh, sorry about that.

So, I just tried that, I booted into rockbox, then connected my USB, the sansa rebooted, and then booted into the OF! >:(

saratoga:
Did you hold select?

meadrocks:
So with Rockbox running, hold the select button, then install the USB. Can I turn the Sansa off at that point and will the unit recharge?

saratoga:

--- Quote from: meadrocks on February 16, 2009, 06:44:47 PM --- Can I turn the Sansa off at that point and will the unit recharge?

--- End quote ---

You can turn it off, but it can't charge unless its on.

Navigation

[0] Message Index

[#] Next page

[*] Previous page