Support and General Use > Hardware

RB hangs immediately after Battery voltage message

<< < (2/2)

Mus:
Thanks BB

I used Swissnife to activate the Primary partition and format to FAT32 then   installed Rockbox using the installation utility.

The iRiver firmware works fine now but Rockbox says 'Loading firmware Result -1'

?

M

AlexP:
Did you definitely get the H120/H140 build and not the H110/H115?

Mus:
The Rockbox utility correctly identified the H140 on the right drive...

There is a .rockbox folder containing the right stuff.

I even replaced .rockbox with all the Rockbox folder/files from my old 60Gb disk and that didn't work either...


Oh well, I put the 60Gb drive back and it still works fine.

If anybody gets any ideas let me know...?







OK. Windows said 111 Gb free. Swissnife said 0 Gb free. I repartitioned again and Rockbox loaded.  :)

I closed the case and got an ATA -11 error but that's a different story.

Glad I asked you guys the questions.   8)

Navigation

[0] Message Index

[*] Previous page