Installation / Removal > Sandisk - Installation/Removal

Sansa c240 01.01.07P to MSC/UMS mode how?

(1/2) > >>

Rick314:
How do I get my Sansa c240, version 01.01.07P, using Windows XP, here in Washington state, USA, into MSC/UMS mode?

I have spent hours reading here and trying things to get Rockbox 3.0 installed.  I've tried "off, on, lock, hold back/rewind, connect USB to PC".  It doesn't connect at all until I release back/rewind, and then as "My Computer\Sansa c240", not a drive letter.  I've read about "rolling back the firmware" but do not understand when this is necessary or how to do it.  In 01.01.07P firmware there is no USB Mode setting.  I have all the right Rockbox downloads and can't get started because I can't get the unit into the required mode.  Dead end, frustration, register just to post this question, hope for help.

Llorean:
Are you leaving the hold switch enabled while you hold Rewing and insert the cable?

Rick314:

--- Quote from: Llorean on December 20, 2008, 01:49:25 AM ---Are you leaving the hold switch enabled while you hold Rewind and insert the cable?

--- End quote ---
Yes.

yapper:
In the OF, look under Settings, USB, then choose MSC.

Rick314:

--- Quote from: yapper on December 20, 2008, 07:26:44 AM ---In the OF, look under Settings, USB, then choose MSC.

--- End quote ---
"In 01.01.07P firmware there is no USB Mode setting."

Navigation

[0] Message Index

[#] Next page