Installation / Removal > Sandisk - Installation/Removal

after install my sansa will not work

<< < (2/3) > >>

LambdaCalculus:
Press and hold the Power button until it powers off (up to 30 seconds).

If this still doesn't work, then open the back of the Sansa and remove the battery, then reinsert it.

bigred:
OK sansa restarted all i get is a blank screen.

LambdaCalculus:
Did you read my instructions above?

bigred:
Do you mean take battery out and put it back in? Sorry  doing that now. Still get a blank screen.

LambdaCalculus:
No, I mean holding the |<< key and then turning your Sansa on. This lets the Sansa boot into the original firmware.

Navigation

[0] Message Index

[#] Next page

[*] Previous page