Support and General Use > Theming and Appearance Customization

Remote hold switch tag for Gigabeat?

(1/2) > >>

afruff23:
I can't get the %mr tag (remote hold switch) to work on my gigabeat. Try this code:

--- Code: ---%wd
%xl|G|hr.bmp|122|12|
%?mr<Remote Hold>
--- End code ---

and then set your remote switch to on.

AlexP:
It is impossible to to tell if the remote switch is on or off due to the hardware.  All the remote hold switch does is block button presses on the remote.

Therefore there is no way that the remote hold tag can work on the gigabeat.

afruff23:
So what targets does it work for?

Llorean:
Any targets with a hold switch on the remote that is software detectable. For example, H100/H300 certainly.

karashata:
H10 models are also software detected.

Navigation

[0] Message Index

[#] Next page