Installation / Removal > Sandisk - Installation/Removal

refreshing database

<< < (2/2)

gevaerts:

--- Quote from: pantherman77 on August 19, 2008, 10:20:51 AM ---weel, if this isn't a rockbox question I'm sorry and this will be my last post. however, before i put rockbox on my sansa, it would only refresh my database after i either added, deleted or modified a file on it. now, every time I start it up, it has to run through this.

--- End quote ---

Did you have it in MSC mode or in MTP mode before? Maybe those behave differently

Llorean:
MTP shouldn't do database updated period.

Unless you have a MicroSD card in. If one is present the database will always update, no matter what, basically.

spodeworld:
Even if a db refresh happens in MTP mode, it is relatively quick.  You may have it set to MSC, which takes a long time to refresh the db. 

>MTP shouldn't do database updated period.

>Unless you have a MicroSD card in. If one is present the database will >always update, no matter what, basically.

JEJ:
Pantherman, read through this topic http://forums.rockbox.org/index.php?topic=18141.0 and maybe you'll find a solution.

Chronon:
That thread is about disabling database rebuilding when booting into the Sandisk firmware (for MSC connections) using the Rockbox bootloader.  I don't think it will give much useful information for pantherman77, since Rockbox has been removed from the Sansa.

Navigation

[0] Message Index

[*] Previous page