Support and General Use > Hardware

Ihp-120 internal foam/rubber?

(1/2) > >>

boxhead:
Where does it go?  There are 2 pieces of foam/rubber inside the 120 that I'm not sure of it's orientation....one I believe is for the HDD to rest in and the other may go under the pc board. (it's kind of blocky S shape with some cut outs)  I just replace my batt and not sure of thier orientation.
I did a FAQ and basic search but didn't see anything that seemed to apply.
Please a little help.

thank you so much in advance.

Multiplex:
From memory (and it was a long time ago that I took mine apart) the S shaped bit goes round the I/O connectors at the top.

Have a loonk in the Wiki here and over at mistic river for pictures if dissasembeld iRivers

boxhead:
thanks!  I did a wiki here and saw ARCHOS but not the 120's photos of disassembly. I'll check out misticriver too.

thanks again!

Multiplex:
Yeah - there are pist of bare boards here for dissasembly this looks like a good one;
http://www.misticriver.net/forums/199333-post33.html

I was a bit short of time yesterday

petur:
there's a better guide in the MR wiki....

Navigation

[0] Message Index

[#] Next page