Rockbox Development > New Ports
Ingenic Jz4740/Jz4732 players
jaining:
--- Quote from: mcuelenaere on January 29, 2009, 09:22:09 AM ---
--- Quote from: jaining on January 29, 2009, 09:19:40 AM ---hi mcuelenaere, do u have app.lds file for vx747? it is missing from tree.
--- End quote ---
No, I haven't added that yet because there's no point in adding support for the main Rockbox firmware due to the lack of (working) storage drivers..
--- End quote ---
but i read forum that u run firmware from sdram once? how possible u build without app.lds?
mcuelenaere:
--- Quote from: jaining on January 29, 2009, 09:28:36 AM ---
--- Quote from: mcuelenaere on January 29, 2009, 09:22:09 AM ---No, I haven't added that yet because there's no point in adding support for the main Rockbox firmware due to the lack of (working) storage drivers..
--- End quote ---
but i read forum that u run firmware from sdram once? how possible u build without app.lds?
--- End quote ---
Because it isn't needed to build a bootloader.
To build the bootloader, only boot.lds needs to be present (which is similar to app.lds).
mcuelenaere:
To people interested in FTL analysis:
I copied a raw NAND dump over USB from my Onda VX747 8GB.
It contains all the non-spare pages (== non-OOB data).
Download link
slowmoe:
hey folks,
i compiled the bootloader and the firmware for the onda vx747 to try it on my 777. when i uploaded it the rockbox logo shows up and it says "ATA error: 11". Does anyone know what that mean?
i copied the firmware to my 8gb microsd card but i don't know if sdhc is supported at the moment, maybe it's the reason for that error.
Here is an image:
http://img-upload.net/images/img-upload.net-da1c5df368fe4e8e17d011541898db7c-img_0250.jpg
thanks and best regards
slowmoe
PS: The power button don't seem to work so i have to wait till the battery runs out of power. :(
mcuelenaere:
--- Quote from: slowmoe on February 13, 2009, 12:50:01 PM ---hey folks,
i compiled the bootloader and the firmware for the onda vx747 to try it on my 777. when i uploaded it the rockbox logo shows up and it says "ATA error: 11". Does anyone know what that mean?
i copied the firmware to my 8gb microsd card but i don't know if sdhc is supported at the moment, maybe it's the reason for that error.
Here is an image:
http://img-upload.net/images/img-upload.net-da1c5df368fe4e8e17d011541898db7c-img_0250.jpg
thanks and best regards
slowmoe
PS: The power button don't seem to work so i have to wait till the battery runs out of power. :(
--- End quote ---
Yes, that's probably something with the SD driver, have you tried the latest revision?
And there's a reset hole on the Onda, just use a small, sharp object (pen or similar) to reset your device.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version