Support and General Use > Hardware

H320 running CF card - problems

<< < (3/3)

hwaitung:
I used a 32G Transcend 133x on my H320 using the bootloader posted on the CFModGuide http://www.rockbox.org/wiki/pub/Main/CFModGuide/H300.zip

and this CF adapter (jumper set to master)
http://www.dealextreme.com/details.dx/sku.10886

The id code I see at boot time is
id[00]=044A
id[82]=7009
id[83]=400C

It works well without the booting issue, guess I am lucky. However original firmware is no longer working.

gap736uk:
Hi all,

After learning that the HDD in my h320 doesn't like being bounced I decided to try the CF mod. I've used a Transcend 32Gb 400x CF card (going cheap on Amazon) with a StarTech.com enclosure . Set to be master. IRiver firmware opens ok (has the usual check HDD connection messages that everyone else reports), and I can see the CF card via USB connection to my PC.

However, I'm getting the ATA error: -80 message.
Not sure what to do next  - any advice would be appreciated!

Gravitonx:
Hi all!

Could someone describe all the actions needed for Iriver H320 CFMod step by step?
I cannot get it clear from Wiki page...

1. What should I do with this file http://www.rockbox.org/wiki/pub/Main/CFModGuide/H300.zip??? I see there's just a .hex file in the archive.
Should I run firmware update from inside the original Iriver firmware on this file? Or choose it in Rockbox utility when installing the Rockbox?
2. For Iriver IHP-100 there is a large detailed bootloader install procedure, and what I see for H300 is a few words with this hex file and with no other stuff like it is with IHP-100
3. What are further steps?
4. What format CF card should have?

It would be so great if someone who succeeded in this stuff helped me with description of each step he made in details.
Thanks a lot in advance!

Navigation

[0] Message Index

[*] Previous page