Support and General Use > Hardware

e260r Load error!

(1/3) > >>

yalcrelyt:
I tried to install Rockbox onto my Rhapsody with these steps:
Download e200rpatcher.exe
If you want to overwrite the Sansa bootloader completely with the rockbox one to save boot time, use this. NOTE: Do this ONLY after you have OF.mi4 in your SYSTEM folder and have unzipped .rockbox to your Sansa's root (see Installation from Windows); you should perform all of these steps EXCEPT copying pp5022.mi4 to your Sansa. Then, run this version of e200rpatcher to complete installation.
WARNING: If you overwrite the Sansa bootloader completely with the rockbox one, you will lose recovery mode and will have to use e200tool if something goes wrong.
Download e200-manufac-driver.zip and extract it somewhere on your computer
Attach your e200R to your computer in manufacturer mode (turn on the hold switch, hold select and plug in USB while continuing to hold select for about 10s)
When Windows asks for the driver, point it to the folder you extracted the driver zip file to
If Windows does not ask for a driver, it means that it has installed one automatically and you must follow these steps before continuing: (For Windows XP, other versions may vary slightly)
Right-click on My Computer, select Properties, go to the Hardware tab, and enter Device Manager.
Under Universal Serial Bus controllers, right-click USB Mass Storage Device (or something similar) and select Update Driver.
Select "No, not this time", then "Install from a list or specific location", and then "Search for the best driver in these locations" and click the "Include this location in the search" box. Now use the Browse button select the location of the drivers and click OK.
Run the e200rpatcher.exe file and follow the prompts. Your Sansa should have some text on the screen. If the last line says "(something) aborted" then head to the forums and look for threads relating to your problem.
If it says "Firmware Unlocked, Proceed to Step 2" then it was successful and you can continue.

I stopped there, disconnected my device, and when I rebooted it, I got the:
"Load main image failed
Switch to Recovery mode"
message.
I tried fixing it in recovery and manufacture mode. Neither worked! Plz help!

MarcGuay:
Did it say "Firmware Unlocked, Proceed to Step 2"?

yalcrelyt:
I'm pretty sure that it did. But when I dis and re connected it, it did that.

MarcGuay:
The point is that the message says to proceed to step 2 if it says "Firmware Unlocked", otherwise, come ask here... So it's kind of important what the message said.  Did you see the link to step 2?

yalcrelyt:
yes, but before I could do step 2, I had to recconnect. When I rebooted, it brought up that screen. Now it won't let me do anything. When I try to leave rec. mode, it just stops on exit usb2.0 msd.
I have to take off the battery

Navigation

[0] Message Index

[#] Next page