Support and General Use > Recording

trigger screen update complaints/issues thread

(1/2) > >>

JdGordon:
reply with any issues/comments/complaints that havnt been mentioned yet...

Davide-NYC:
OK I just installed the patched build provided on an H120.

Problems:


* The setting do not take effect immediately. One has to highlight an adjacent line (up or down) before the setting takes effect.
* The two-line-per-parameter display is confusing. Putting the Label on the Left and the Value on the right of a single line should be clearer. It also allows everything to be on the H120 screen at once without sdcrolling.
* The left icon (Stop square) does not change in the trigger screen. (it works in the WRS)

That's what I found so far. I'll test again once a new version of the patch is provided. Please provide the build zip. I was unable to patch cleanly. Must be some parameter of "patch" that I'm not familiar with.

Thanks for this!

LambdaCalculus:
Did you use the -p0 parameter to apply it? Like so:


--- Code: ---patch -p0 < patchfile

--- End code ---

This should allow it to apply clean.

Davide-NYC:
I tried multiple "p" levels and couldn't get it to apply without having to input every file path. I was too lazy to do so since the zip was available. ;-)

JdGordon:
new version is on the tracker... try it out.. or just put up bug reports after its in svn...

Navigation

[0] Message Index

[#] Next page