Support and General Use > Hardware

*PANIC* ATA: - 71 what does it means

<< < (2/3) > >>

petur:
hmmm reading the code again it could be 'set_features' or 'set_multiple_mode'

the calls are quite late in the disk init process, so this really puzzles me. Disk failures would have triggered an earlier call than those :(

RenatoN:
I just tried booting up this morning and it boots into rockbox.  I press play and it resumes playing.
When I attempt to get into settings it goes into USB.  About 20 seconds later the "Panic ATA -71" comes up. 

It requested to debug and the following displays:

GPIO_READ D81A7888
GPIO_OUT: 00080888
GPIO_FUNC: B1ED1AC8
GPIO_ENA: B1ED0AC8
GPIO1_READ: 0798A76E0 changes back and forth to 0798B76E0
GPIO1_OUT: 010A4008
GPIO1_FUNC: 019E60EE
GPIO1_ENA: 010E400C
ADC_BUTTONS: FF
ADC_REMOTE: FF
ADC_REMOTEDETECT: E4
Batt: 3.866V 59%
remotetype: 0


Does this help?

Renato

Multiplex:
Is it possible that this is a manifestation of the USB / disk connector board having poor connection to the main board problem?
it was the going into USB mode that made me think of it

RenatoN:
It could be since the same thing happens in the original firmware.
How difficult is a repair like that?  I have replaced the battery and hard drive, but no experience with soldering.


Renato

NuJew:
It happen to me after change the battery to 2300mAh too,
my unit was bought since it first released.

Navigation

[0] Message Index

[#] Next page

[*] Previous page