Installation / Removal > Sandisk - Installation/Removal

Ukraine online ....still need help with sansa e280r

(1/4) > >>

tmt:
OK in this time I'll tried  my best with my english so I hope some body will understand me and HELP me!!!
So....I tried to install rockbox   everything was looking good but after installing nothing happened/ it was just screen which was showing just sandisk screen saver & that was it.when I backup the old version of firmware. & then I tried to install rockbox again but when I tried to patch it, it did not detect sansa in right way so I read how to make it back  & I tried to instal i2c-e280.bin and everything was going good but somewhere after 5 minutes of waiting it was looking like it's stuck on one point so I just remove battery and after that it does want to work in any way not in recovery mode not in any other ... just blue button & that is it.... I realy need help    
 Thanx for you time hopу somebody will understand Ukrainian english  ;D

AlexP:
I have removed your other thread as you have just started this one that is identical.  Please have some patience.  If someone reads it who knows the answer I am sure they will try to help.

zajacattack:
Since you interrupted it writing the i2c rom, it is probably in pre-boot mode.

Follow the instructions at http://www.rockbox.org/twiki/bin/view/Main/SansaE200Unbrick#Pre_boot_Mode

tmt:

--- Quote from: zajacattack on March 15, 2008, 05:55:38 PM ---Since you interrupted it writing the i2c rom, it is probably in pre-boot mode.

Follow the instructions at http://www.rockbox.org/twiki/bin/view/Main/SansaE200Unbrick#Pre_boot_Mode

--- End quote ---

I would like to but I can NOT get to the recovery mode!!!! :(
non of the buttons want еще work not "middle" one not "rec"

zajacattack:
You have to fix the i2c rom, then use e200tool to boot into recovery mode. I said you were in PRE-BOOT mode, which is different than RECOVERY mode (see "Sansa USB Modes" at http://daniel.haxx.se/sansa/e200.html)

Navigation

[0] Message Index

[#] Next page