Support and General Use > Hardware

IRIVER ihp 120 and CF

<< < (2/5) > >>

radionico:
and also, I just ordered on ebay a 16GB a-data CF, I hope it will works with my IHP 120 ;o)

LinusN:
It might require some research. You can begin with giving me all the information from the Disk info debug screen.

radionico:
this disk debug screen is in the rockbox/settings/debug ?

GodEater:
Correct.

radionico:
Bonjour ;o)

here are the disk info when I use a transcend 2GO CF card.
  Diskinfo avec carte transcend 2 GO

Model: transcend
Firmware: 20050811
Size: 1983MB
Free: 587MB
Spinuptime : 100ms
Power mgmt: unsupported
Noise mgmt: unsupported
PIO modes: 0 1 2 3 4cycles times: 120ns/120 nsIORDY support: noIORDY disable: no
Cluster size: 4096 bytes

with this card, my Iriver 120 seems to work well (sometimes for a few hours) , but sometimes it freeze, and I have to use the reset button to make it work again...And sometimes it's not enough, and when I reset it it boot with the old Iriver firmware.  to resolve this problem I have to open the iriver, disconnect the card and re- copying the rockbox file from my PC.

And it works again, until the new freeze ;o)


And when I try to use my transcend 16GB card,, I cannot get disk info  data from the rockbox debug menu, as the card is not recognised and I have the "ATA error: -OO" message

here are the specs of the CF card

[Ultra-fast 133X performance with dual-channel support
- Conforms to CF Type I standards
- Data transfer rate: 21.5MB/sec(Max)*
- Supports Ultra DMA mode 0-4**
- CompactFlash 4.0 compliant
- Built-in hardware ECC technology for detecting and correcting errors
- ATA interface
- Low power consumption
- Multi-platform compatibility
- RoHS compliant
- Lifetime Warranty
** Note: Default setting: Ultra DMA 4 "
here is a link to the full caracteristics of the card from the manufacturer:
http://www.transcend.nl/support/dlcenter/datasheet/Datasheet%20CF133_1GB_32GB_.pdf
iT IS SUPPOSED TO BE "TRUE IDE"

Is there something suspicious regarding the ""default setting: ultra dma" note ?

Thank you for your patience, and sorry for my unperfect english...

Nicolas

Navigation

[0] Message Index

[#] Next page

[*] Previous page