Rockbox.org home
Downloads
Release release
Dev builds dev builds
Extras extras
themes themes
Documentation
Manual manual
Wiki wiki
Device Status device status
Support
Forums forums
Mailing lists mailing lists
IRC IRC
Development
Bugs bugs
Patches patches
Dev Guide dev guide
Search



Donate

Rockbox Technical Forums


Login with username, password and session length
Home Help Search Staff List Login Register
News:

Thank You for your continued support and contributions!

+  Rockbox Technical Forums
|-+  Support and General Use
| |-+  Hardware
| | |-+  error message connecting my Sansa e250 after rockboxing it
« previous next »
  • Print
Pages: [1]

Author Topic: error message connecting my Sansa e250 after rockboxing it  (Read 1161 times)

Offline clutch

  • Member
  • *
  • Posts: 21
error message connecting my Sansa e250 after rockboxing it
« on: January 11, 2008, 01:09:02 PM »
This isn't stopping me from using it but I get this message after rockboxing my E250R each time I connect.  Any ideas?




Thanks,

Clutch
Logged

Offline MarcGuay

  • Rockbox Expert
  • Member
  • *
  • Posts: 1065
Re: error message connecting my Sansa e250 after rockboxing it
« Reply #1 on: January 11, 2008, 07:21:23 PM »
Are you connecting with the Sansa firmware or Rockbox?
What do you have USB Mode set to in the Sansa firmware?
Logged

Offline clutch

  • Member
  • *
  • Posts: 21
Re: error message connecting my Sansa e250 after rockboxing it
« Reply #2 on: January 11, 2008, 08:25:32 PM »
Both Powered down inserting cable and using the left arrow to power up booting sansa software give this error.  Just started immediately after the rockbox install.  

I'm not sure what mode but it what one has to use to connect to w2k.  I can't seem to find were I set that ages ago.

Clutch
Logged

Offline MarcGuay

  • Rockbox Expert
  • Member
  • *
  • Posts: 1065
Re: error message connecting my Sansa e250 after rockboxing it
« Reply #3 on: January 11, 2008, 08:48:59 PM »
The USB Mode can be found in the Sansa firmware settings menu.  I haven't a clue if that information will actually help but it should be set to MSC/Rhapsody.
« Last Edit: January 12, 2008, 12:24:29 AM by MarcGuay »
Logged

  • Print
Pages: [1]
« previous next »
+  Rockbox Technical Forums
|-+  Support and General Use
| |-+  Hardware
| | |-+  error message connecting my Sansa e250 after rockboxing it
 

  • SMF 2.0.17 | SMF © 2019, Simple Machines
  • Rockbox Privacy Policy
  • XHTML
  • RSS
  • WAP2

Page created in 0.065 seconds with 15 queries.