Installation / Removal > Sandisk - Installation/Removal

Sansa e250R - Unable to get into manufacturer mode

<< < (2/2)

Bagder:
The NSLU2 has an ARM core so you can't run the (x86) Linux binary that we offer for download. You'd have to (cross-) compile your own e200rpatcher for your particular target...

avgjoe:
Oops!  Thanks, Badger! That would have been a wasted effort.  Didn't notice it was for the x86 targets only.  At this point I think I'll try to borrow someone else's WinXP machine as setting up a proper dev env on the NSLU2 is going to be an undertaking and getting Linux to run on my notebook has not been successful due to the the integrated chips on it.

jsauser11:
I had the same issue with my wife's E250R when I first tried to do the Rockbox install.  WinXP would not call up the new hardware wizard.  So, I moved the USB cable to an alternate port on the same computer, and then the Sansa would enter Mfg. mode correctly, and I got the WinXP hardware wizard.  So, if I were you, try moving the cable to another USB port on the same computer if you have one, and try the install again.

avgjoe:
Update: I tried on the alternate USB port on my machine and it didn't recognize it still, but on the other PC it worked like a charm.  Thanks so much for your help :)

Navigation

[0] Message Index

[*] Previous page