Rockbox Development > New Ports
SanDisk Sansa c200v2, m200v4, clipv1, clipv2, clip+, and fuzev2
fragilematter:
To get the bootloader to work on e200v2s (or at least the 2GB e250v2) the start variable in rockbox/firmware/target/arm/as3525/ata_sd_as3525.c at line 522 needs to be set to 61440.
Now, if I'll get RB to compile we might even see a menu...
JdGordon:
works on my 2GB e200v2 also :)
linuxstb suggested in IRC we fake a partition table instead of adding this hard coded value to the sd driver and I agree (I'll maybe give this ago tomorow after my last exam :D ).
Is this value going to be the same for all e200's? is there any way it doesn't need to be hard coded?
mc2739:
I think it should be the same for all e200v2, since they all use the same firmware. It will probably be different for the fuze.
JdGordon:
I've commited that quick fix as a temporary work around untill something better happens.
Bagder:
1. The AMS version of the m200 is now called m200v4 in Rockbox to match the name SanDisk themselves use for this device
2. The e200v2, m200v4, clip and fuze now get their bootloaders built in the build table to make sure they remain buildable.
I propose we refer to these newer model Sansas as "AMS Sansas" and not V2 or anything since there are many other version numbers involved.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version