Rockbox Development > New Ports
SanDisk Sansa c200v2, m200v4, clipv1, clipv2, clip+, and fuzev2
HorizonGrey:
Just rockbox'd my fuze v2 serial BI0903BLAK-8GB, works great thanks everyone for the hard work. I have patiently waited for this to be completed and not disappointed!
id:
Something weird just happened with my Fuze v2. I compiled a Rockbox from source ( Version: r26433-100531 ) and installed it.
Then I wanted to test USB charging mode so I pressed left button and pluged the USB.
Since I've done that everything is off and it's not responding to anything.
I tried holding power button for a whole minute, I tried plugging it in and out from USB. Nothing works and nothing shows up in dmesg.
Has anyone any idea what happened to my Fuze ?
funman:
have a look at this post
funman:
there could be a bug in USB detection but it's not clear what happens there (or if there is any bug at all)
btw, to prevent rebooting you have to press center button.
left button is the one to press when you power up with the power button and want to boot OF
--- Quote from: funman on May 31, 2010, 04:28:04 PM ---I could unbrick the fuzev2 (back to business), the fuzev1 (although the OF won't start), and an old clipv1 I had bricked one year+ ago (although the battery doesn't seem to charge).
I'll see if I can have the fuzev1 and clipv1 working fully and I'll update the wiki pages with what I did.
--- End quote ---
I created SansaAMSUnbrick.
If you find spelling errors or want to clarify the wording, feel free ^^
I had to copy the whole reserved part from another Fuzev1 to have the OF work on this one.
The bootloader r20603 came with it and it seems it's much faster than the v1 bootloader - perhaps something to come in the next days.
The Clipv1 works fine except I had removed the jack from it to make a longer jack cable.
I soldered the jack from another PCB but now I have a lot of noise in the phones.
Also the battery doesn't seem to charge (in the OF or rockbox).
When I boot rockbox and plug USB the voltage readout decreases to ~3.0V and rockbox battery debug says charger absent / discharging, although the charger icon is shown in the status bar.
bertrik tried to find the pins on c200v2 without luck so far and JDGordon will try on Clip+.
lazy:
for some reason, my clip+ stopped charging via usb via rockbox at ~68%
using the build r26441 i think (whatever was on the site 3 days ago)
tired replugging, didnt do anything, booted back to original firmware to charge it now
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version