Rockbox Development > New Ports
SanDisk Sansa c200v2, m200v4, clipv1, clipv2, clip+, and fuzev2
ubbut:
@Xanikseo
I a experienced the same problem (clip+ crashes at the end of a track) and currently i have to wait until the battery is low the boot again.
Is there any possibility to reset the device?
edit: ok just got it: you have to hold the power button very very long (i only tried to hold it very long)
thx
I will also test the new patch and see if it still crashes
ssorgatem:
Has anyone tested rockbox for the fuzev2 built with the eabi toolchain? I'm currently running it, and it works great! (in previous revisions it wouldn't even boot).
So far, I haven't had any issue I wouldn't have had with a "normal" build.
PD: is doom working for anyone?
mc2739:
--- Quote from: ssorgatem on May 11, 2010, 06:46:54 PM ---Has anyone tested rockbox for the fuzev2 built with the eabi toolchain? I'm currently running it, and it works great! (in previous revisions it wouldn't even boot).
So far, I haven't had any issue I wouldn't have had with a "normal" build.
PD: is doom working for anyone?
--- End quote ---
Doom is known to have problems when using the eabi toolchain.
ssorgatem:
True, with non-eabi doom.rock it works :) (in a eabi-built rockbox)
funman:
--- Quote from: funman on May 11, 2010, 10:25:30 AM ---doing it like the OF (increase/decrease the dividers one by one) seems to work too; and the advantage is that we can explain why: "the OF does it"
--- End quote ---
Doesn't work
With FS#11257 recording should work fine (only tested on Clip+ so far)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version