Rockbox Development > New Ports

SanDisk Sansa c200v2, m200v4, clipv1, clipv2, clip+, and fuzev2

<< < (327/386) > >>

bilditup1:
Interesting. So do you have any other suggestions then? Should I proceed by using random inputs for udelay less than 10000? I'd like to help but really don't quite know what's flying here ;)

kugel.:

--- Quote from: bilditup1 on May 03, 2010, 08:54:27 AM ---Interesting. So do you have any other suggestions then? Should I proceed by using random inputs for udelay less than 10000? I'd like to help but really don't quite know what's flying here ;)

--- End quote ---
Yes, you could bisect the needed delay. E.g. start with 5000, then try 2500 or 7500 depending on the success, then 1250 or 3750 (assuming 2500 worked). Basically always half the interval, and add or subtract it from the current number, until the interval is like 50.

funman:
Write support committed in r25799, should work on all models including µSD.

Unless of course the µSD isn't detected in the first place :)

EDIT: Please run a battery bench and post the results (with model, revision, volume, and DSP effects enabled), and pray for it doesn't crash while benching :)

xiang:
holy shit.. i've waited so long for this!!! thanks!! i'll donate some money to u guys. when are the new builds up?

funman:
The current builds are at the usual address:
Clipv2
Clip+
Fuzev2

Navigation

[0] Message Index

[#] Next page

[*] Previous page