Rockbox Development > New Ports
SanDisk Sansa c200v2, m200v4, clipv1, clipv2, clip+, and fuzev2
funman:
FlynDice, looks like it is working on both Clip & Fuze
Do you think we'll have to upgrade the bootloaders for 3.5 release after all the modifications you made to SD driver ?
BlastTyrant:
--- Quote from: FlynDice on December 10, 2009, 08:46:03 PM ---Still need someone to test FS#10838 on a clip &/or fuze please.
--- End quote ---
Just patched r23928 with the diff and tested it out for 20 minutes or so. I did 15 power on/off and let it play for around 15 minutes. I had no issues running it on my Fuze.
IDE is set to 50MHz. Actual shows 49MHz.
SD (internal ?) is running at 25MHz.
8GB cl6 Transcend uSD is running at 31MHz (50.0MBit/s).
1GB cl2 Sandisk uSD is running at 15MHz (25.0MBit/s).
FlynDice:
funman
I don't think we would have to but quite honestly you would probably have a better feeling for that than I do. I'm running a bootloader built off of r23799 right now but I was running off of one from August until just before that. We would still be overclocking the internal card with the present bootloader but it seems to work fine. I guess what it comes down to is if we want to spend the time to make it technically correct or is the fact that it "just works" good enough?
Once again , thanks all for the testing!
saratoga:
We don't even know what the internal memory is speced for, so if its working I wouldn't worry too much about trying to conform to some spec that may not even apply.
FlynDice:
Well, I have finally managed to get 4 bit widebus working ;D !!
I had to fly all night though so I'm going to get some shuteye and clean it up when I'm a little more coherent.
In order to head off kugel's question I'll post the speed tests now. UNS = UNALIGNED_NUM_SECTORS
http://pastie.org/741378
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version