Rockbox Development > New Ports
SanDisk Sansa c200v2, m200v4, clipv1, clipv2, clip+, and fuzev2
yelped:
Is there a line-in wired in?
saratoga:
--- Quote from: yelped on November 28, 2009, 07:32:36 PM ---Is there a line-in wired in?
--- End quote ---
If there is, the Sandisk firmware/accessories don't use it.
Edit: Soap sent me this link:
http://www.chargeconverter.com/shop/connnopod.htm
If you want to look for recording, the break out board there would be an obvious way to see if any of the pins work as line in.
MartyLK:
I'm happy to report that I turned off the Shuffle and now my c200v2 will continue to play music after the first full song and after a track skip. Before, my c200v2 would stop playing after the first song played through or after a track skip. Now, however, with Shuffle off, it will continue to play without stopping.
EDIT - Ooops, I spoke too soon. My c200v2 plays more than one track, but stops after about the 3rd track.
kugel.:
--- Quote from: saratoga on November 28, 2009, 06:01:34 PM ---DBOP_DIN9 changes when a fuze dock (which uses external power to pull the dock pin high so scanning isn't needed) changes. But thats also GPIOB7, which apparently did not change according to that thread, so I'm a little confused.
--- End quote ---
We're currently only configuring those pins for output for which we know there's a button on it so the dock pin might go invisible in the debug screen. With bertrik's dbop patch, we won't be reading buttons from GPIO but only via DBOP anymore though.
FlynDice:
I need some tests on targets other than e200v2 for this:
http://www.rockbox.org/tracker/task/10825
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version