Rockbox Development > New Ports
SanDisk Sansa c200v2, m200v4, clipv1, clipv2, clip+, and fuzev2
NTS1:
Narann,
Cheers for all your hard work.
Thanks to your mkamsboot.exe I now have my Fuze dual booting with Rockbox and the latest Sansa firmware. This is a huge improvement over the old firmware usually needed to get Rockbox working, it gives direct folder access to files etc. It's very useful to be able to switch between this and Rockbox to compare sound quality etc.
Many thanks again! :)
Toxeus:
Hope it's right topic to ask:
is there any way to disable pause from turning the hold switch up (in sansa clip build)?
AlexP:
--- Quote from: Toxeus on November 19, 2009, 02:58:34 PM ---is there any way to disable pause from turning the hold switch up (in sansa clip build)?
--- End quote ---
Could you rephrase this, I have no idea what you mean :)
Toxeus:
My english is quite bad, sorry
When i turn the hold button from on to off and if i push it too far (toward the power off position) my playback pause. It doesn't happen on fuze and it's pissing me off on clip >:(
mc2739:
--- Quote from: Toxeus on November 20, 2009, 12:39:49 AM ---When i turn the hold button from on to off and if i push it too far (toward the power off position) my playback pause. It doesn't happen on fuze and it's pissing me off on clip >:(
--- End quote ---
The Fuze has a protection so that the power switch is not read immediately after the hold switch is released. I have created FS#10796 to add this same protection to the Clip.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version