Rockbox Development > New Ports
SanDisk Sansa c200v2, m200v4, clipv1, clipv2, clip+, and fuzev2
funman:
I'm hoping this could be due to invalid FAT filesystem leading to transfer_sectors request for invalid sectors.
However I can not be sure of that.
Ideally we would check that the sectors requested do fit in the size of the block device, but we do not know the number of blocks for 4GB and +
The size reported by CSD register is the size of 1 bank and we do not know the number of banks.
I have not found how the OF deals with this (and it HAS to deal with it for USB MSC), so I suggest these:
* Wait for someone to write an USB driver before caring (that was what I had in mind)
* Try to detect the number of banks by trying to switch to the next bank until it fails
FlynDice:
Looks like another rocky road for voltage scaling:
Fuze Whitescreen Report
Any ideas?
funman:
hmm.. perhaps he can try with 1.15V
LiquidAcid:
Hi, I just updated my Fuze to r23201-091016 and I'm also experiencing this whitescreen issue. I can see the bootloader output, but after that the screen turns white. Kinda looks like the lamp application is loaded :D
kugel.:
--- Quote from: LiquidAcid on October 16, 2009, 10:34:44 AM ---Hi, I just updated my Fuze to r23201-091016 and I'm also experiencing this whitescreen issue. I can see the bootloader output, but after that the screen turns white. Kinda looks like the lamp application is loaded :D
--- End quote ---
With, or without microsd inserted?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version