Rockbox Development > New Ports
SanDisk Sansa c200v2, m200v4, clipv1, clipv2, clip+, and fuzev2
sko:
--- Quote from: funman on July 03, 2009, 10:45:02 AM ---When you see a data abort, you should write down the address written on screen, and disassemble your current rockbox.elf (or the codec you use if the data abort is in the codec), to see which code does produce it.
Or you can come on irc to give the elf file + faulty address to a developer (it's a bit big to be attached to the forum thread)
--- End quote ---
Yes, I'll do that next time. I'll try it again if I am at home, maybe it was related to the sd-bug and it has been fixed with the last commits (it happened before these fixes).
fragilematter:
Hey guys! Just a quick follow-up on the micro sd not working problem on (some of) the e200s. If it wasn't clear already, this problem is induced by FlyingDice's low core voltage patch.
I reverted system-as3525.c to r21282 (pre FS#10344) and the sd is working just fine.
I may come back with a week's worth of data aborts (if any) during this holiday. Cheers!
FlynDice:
Yes that's the same as MC2739 reports also. I have had what seems to be the same problem in the past but I'm not experiencing it now. Just to clarify, we're talking 8GB microsd on an e200 right?
fragilematter:
Nope, it's just a 1gig Kingmax micro-sd on an e200 (e250 to be precise). Dunno, some sd cards might need a more precise timing and the voltage switch is throwing the timing a bit off, just guessing here...
Hillshum:
My 2gb SanDisk (plain ole SanDisk, nothing fancy) uSD isn't working in my e260v2.
Also, test_disk has given me a couple of
*PANIC*
flush_fat_sector() - Could not write sector 321 (error -101)
with two different sectors on write & verify. I have gotten plenty of clean runs as well, though I suspect hardware issues.
Additionally, the database isn't updating itself like it should. I unplug from USB having transferred a bunch of files, boot into rockbox, and then need to reboot again to get the database updated.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version