Rockbox Development > New Ports
SanDisk Sansa c200v2, m200v4, clipv1, clipv2, clip+, and fuzev2
funman:
notlistening have you checked FS#10267 ?
Now you should update your forum signature (perhaps change it to "not listening to any radio") :)
ej0rge sent me a c200v2 and i could get lcd to work (still buggy : sometimes there's no output in the bootloader), and it looks like it has the same problem than e200v2 for the radio, and the same problem than clip for playback.
Hopefully it will help fixing those ..
sko:
Hi, back again, had not much spare time last two weeks. I updated FS#10284 with my actual attempt of an unified driver for fuze and e200v2.
aaron424:
the fuze v2 does not even have a development version yet, right?
"Fuze v2
Sansafix at the Sansa forums has announced that a v2 of the Fuze has been released. There are no noticeable differences, but there is a different firmware version that is incompatible with V1 Fuze firmwares. Presumably based on an AS353x CPU like the ClipV2.
The v2 devices are in the wild. Attached are photos of the upperside of the board and the underside."
saratoga:
--- Quote from: aaron424 on June 27, 2009, 12:05:17 PM ---the fuze v2 does not even have a development version yet, right?
--- End quote ---
Correct. See this page for an overview of whats done on each AMS device:
http://www.rockbox.org/twiki/bin/view/Main/SansaAMS
funman:
Hi all,
I have committed r21550 which fixes a problem in SD bank selection (also used at startup to enable access to the whole 1st bank).
If you still experience problems after updating to this revision please tell us, and precise if you see filesystem corruption or deadlock at startup.
To rule out problems with previous filesystem corruption, please format your player and reinstall rockbox before reporting.
P.S. I hope nobody will report any problem ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version