Rockbox Development > New Ports
SanDisk Sansa c200 v2
inoesomestuff:
--- Quote from: Bagder on November 24, 2007, 05:17:29 AM ---"turn on the device while HOLD is on, then press and hold 'rewind' while attaching the cable."
--- End quote ---
thanks, this also works for e280 v2
robertjm:
Maybe I'm missing something here. I did the same, but the unit (e280) doesn't give you enough time to connect the usb cable before it enters shutdown mode, less you've got four arms!!
Robert
--- Quote from: Bagder on November 24, 2007, 05:17:29 AM ---......For the c200v2 there's supposedly this trick: "turn on the device while HOLD is on, then press and hold 'rewind' while attaching the cable."
--- End quote ---
vulpesferox:
--- Quote from: Bagder on November 24, 2007, 05:17:29 AM ---Do note that the topic of this thread is c200 v2, not e200 v2 but let's treat them similar for a while.
Well, how do you do it when you upgrade firmware on the e200 v2? For the c200v2 there's supposedly this trick: "turn on the device while HOLD is on, then press and hold 'rewind' while attaching the cable."
--- End quote ---
My apologies for not paying attention to which board I was on when posting!
I have not been successful in using the above mentioned technique.
Btwizt:
if it helps at all, i recently upgraded the stock firmware on my c250 V2 tot eh newest firmware and copied the file the updater put on my c250 to my HD, if you guys wnat it, jsut ask. its a 5meg .bin file.
Bagder:
Yes I would like it!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version