Rockbox Development > New Ports
SanDisk Sansa c200 v2
xoring:
Speaking of stupidity... I recently bought a c200 from Woot! and tried to install Rockbox on it. I followed the instructions and it seemed to boot rockbox fine. I loaded some music on it and tried to play it but kept getting errors. I went on rockbox.org to see what was up and realized I had a v2. :(
So it looks like I somehow got Rockbox *partially* installed on a c200v2... I think?
Bagder:
No, it just means you bought a v1 that is labeled v2 on the outside. You're not the first to experience this.
Btwizt:
i tried to crack my v2 open today but ahd tos top as i cant get a looka t teh back side of teh PCB without breaking some plastice tabs holding the pattery sheild on.
LambdaCalculus:
--- Quote from: Btwizt on December 04, 2007, 10:59:25 AM ---i tried to crack my v2 open today but ahd tos top as i cant get a looka t teh back side of teh PCB without breaking some plastice tabs holding the pattery sheild on.
--- End quote ---
Not to be mean, Btwizt, but please spell check your posts before you submit them. Letters in awkward places makes it hard to read some of your posts.
If you want safe instructions on how to open a Sansa, try the AnythingbutiPod forums.
xoring:
--- Quote from: Bagder on December 03, 2007, 05:24:57 PM ---No, it just means you bought a v1 that is labeled v2 on the outside. You're not the first to experience this.
--- End quote ---
In that case, why am I still getting codec errors? I followed the steps in the install instructions, the same mp3s play fine on a Rockboxed e280.
Actually, the more relevant-to-this-thread question is: How do you tell the difference between a v1 and v2 if the label on the outside is possibly incorrect?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version