Rockbox General > Rockbox General Discussion

E250 refreshing database

<< < (2/2)

interframe:
If I am following you, yes that would be correct. Plugging in the USB cable from the off state will turn on the e200 and let it charge. However the unit was not recognized by my PC.

hoho:
Same behaviour here on e260. I just unplug and plug it, without turning off, again and it works.
Another workaround is to let the original firmware boot once after changing files on the player, so it doesnt do a refresh on plug.
Dont have an SD card.

dana7:
Here's how it works on my e280

1)  Plug in the usb and the player will boot into the original Sansa firmware and begin the L O N G process of refreshing the data base.  Wait for this to finish.  During the refresh, the player will not be recognized by windows.

2)  After the refresh is finished, simply unplug and re-plug the usb.  The player will then be seen.

3)  Do what you need to do.

Navigation

[0] Message Index

[*] Previous page