Rockbox Development > New Ports
iriver clix2 port
linuxstb:
Did you try all possible buttons (and maybe combinations of buttons) ?
The Logik DAX player that I'm currently porting Rockbox to doesn't have a standard button to enter USB boot mode either. I discovered two other ways to enter it:
1) Disassemble the player and physically disconnect the NAND flash from the main board. The Telechips CPU appears to default to USB boot mode if there is no NAND flash available...
2) The main board on my player has some contacts near the CPU, marked "USB" and "NAND". Normally the "NAND" contacts are soldered together. By unsoldering them, and attaching a switch I am now able to choose either NAND or USB boot mode. You can see these contacts on this photo of my player - just to the left of the CPU:
http://www.davechapman.f2s.com/logik/main_board.jpg
vcf:
it seems to me that one time i really opened usb boot mode!but the second time i tryed it the pc wont recognize clix2!when i choosed nand it worked like a usb mass storage again.but if we can turn clix2 into usb boot mode for what do we need that?we wont disassemble clix2 every time when we want to run rockbox,wont we?
linuxstb:
--- Quote from: vcf on October 29, 2007, 09:52:30 AM ---it seems to me that one time i really opened usb boot mode!but the second time i tryed it the pc wont recognize clix2!when i choosed nand it worked like a usb mass storage again.but if we can turn clix2 into usb boot mode for what do we need that?we wont disassemble clix2 every time when we want to run rockbox,wont we?
--- End quote ---
I'm sorry, I don't understand what you're saying.
You say that "one time i really opened usb boot mode" - exactly what did you do, and exactly what happened on your PC? If you did it once, then that means your Clix2 has a way to access it.
vcf:
i did this 1) Disassemble the player and physically disconnect the NAND flash from the main board. The Telechips CPU appears to default to USB boot mode if there is no NAND flash available... but it worked only one time!the pc showed it like a usb device!oyher times i tryed this the pc didnt show anything!
all other people who are intersted in port to clix2 please try on of this ways to recognize usb boot mode to make sure that it works!
vcf:
yes!i did it!the pc recognizes clix2 like a usb device without nand flash(or whe usb is choosed)what does that give?is that important which way we use to enter usb boot mode? what should we do next?for what i was cheking the usb boot mode?are there pleers with telechips which havent got usb boot mode?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version