Rockbox General > Rockbox General Discussion
How to use Rockbox, iRiver H120 and Mac osX?
Domonoky:
So you have the right device selected, but no mountpoint is set..
please go into the Configuration and set the mountpout to where your device is mounted in the Filesystem. Then it should work.
jamato8:
So how do I do that? Sorry for my ignorance but this is all new to me.
I went to the file menu and did a browse and inserted H100 as the software will not auto detect. It says it downloads and loads to files and that installation was succesful but nothing happens and I don't see it in the files of the H120. ??
Chronon:
The mountpoint is "where" on your system the device is mounted. I'm not sure of the syntax for OS X. Hopefully someone who uses that OS can give you more direct instructions.
jamato8:
What does "mounted" mean in terms of the device? I have have downloaded the patch but the Mac osx does not recognize it so I can open it to patch the firmware.
soap:
Something I think the others have forgotten to mention is that your iPod, I assume, is formatted HFS+ - a so called "MacPod".
Rockbox only works on iPods formatted FAT32.
This is covered in the "note" at the end of section 2.2 of the manual.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version