Support and General Use > Plugins/Viewers

MPEG on c200

(1/1)

gigermunit:
Anyone willing to tell me the settings to use in winff for a video on a c200?

im speaking of the code parameters to enter specificly.

Llorean:
Just use the e200 preset, then put in the width and height for the c200's screen size instead, and it should be fine. If you want you can cut the bitrate by about 20-30% from where it is for smaller filesize, it's probably a good deal higher than necessary for the c200's screen.

gigermunit:

--- Quote from: Llorean on September 30, 2007, 08:18:43 PM ---Just use the e200 preset, then put in the width and height for the c200's screen size instead, and it should be fine. If you want you can cut the bitrate by about 20-30% from where it is for smaller filesize, it's probably a good deal higher than necessary for the c200's screen.

--- End quote ---
the height and width is 132x80 right?

lowlight:
Video does not work on the c200 yet (it only plays the audio portion). Someone needs to write the appropriate lcd display routines for actually showing the video.

gigermunit:

--- Quote from: lowlight on October 01, 2007, 03:06:49 AM ---Video does not work on the c200 yet (it only plays the audio portion). Someone needs to write the appropriate lcd display routines for actually showing the video.

--- End quote ---
yeah i noticed it when i was playing the video that there was no visual but the audio decoded fine.

Navigation

[0] Message Index