Installation / Removal > Sandisk - Installation/Removal

E250R "Load main image failed" after running install steps

<< < (3/4) > >>

scorche:
I got that as well when I installed Rockbox for the first time.  It stopped when I mounted the device.

clutch:

--- Quote from: scorche on September 06, 2007, 12:33:47 AM ---I got that as well when I installed Rockbox for the first time.  It stopped when I mounted the device.

--- End quote ---

The bit about the scrolling LUN0 lock, unlock might be nice to add to the current instructions.

That gave me confidence to try from scratch again.  

Now I get :

Rockbox boot loader
Version: 20r12485-070225
Sandisk Sansa E200
Partition 0: 0x06 1896 MB
Loading Rockbox ...
Error!
Can't load rockbox.e200:
File not found

Then it shuts down.

I'm going to review the troubleshooting links given by other responders and see if I can make more progress.  

Thanks,

Clutch

scorche:
Did you install a current build to the root of the device, as the instructions say?

clutch:

--- Quote from: scorche on September 06, 2007, 08:49:26 AM ---Did you install a current build to the root of the device, as the instructions say?

--- End quote ---

That I know I did.  Just for reference I put  the build at root of the partition that holds music and such in a .rockbox directory  I hope root was supposed to start with a directory .rockbox.  

After I got this to run the rockbox loader, I tried to follow instructions to take this back to original firmware.  Now I get that Load image failed message and redoing the installation instructions doesn't seem to get me out of this.  

Well, I have to go to bed.  Work midnights.  I'll flog on it tomorrow.

chrisjs169:

--- Quote from: clutch on September 06, 2007, 08:45:48 AM ---
Version: 20r12485-070225
Sandisk Sansa E200
Partition 0: 0x06 1896 MB
Loading Rockbox ...
Error!
Can't load rockbox.e200:
File not found

--- End quote ---
That's an old bootloader...

Navigation

[0] Message Index

[#] Next page

[*] Previous page