Installation / Removal > Iriver - Installation/Removal/Flashing
Flashed Rockbox H140 problems
dunno:
If I were you I wold do a "CLEAN" install of rockbox with the most current build, I have also flashed Rbox to Rom and have no problems at all with the recent current build.
I follow the instructions on the page below when flashing to ROM
http://www.rockbox.org/twiki/bin/view/Main/IriverFlashing
PinkZeppelin:
Yes, I followed those directions as well.
I did do a clean install (although the [SQUARE]D file in the rockbox directory has never been able to be deleted, even before rockbox flashing)
There were no errors found on the drive, but the same "no files" and "filetype array full", and the player freezes when trying to play files, all when running in ROM or RAM mode.
Disk mode runs fine, barring looking in the version menu, which freezes.
Bootloader version is 7-pre3
I think the problem lies here:
When booting in disk mode, the version says 070815
When booting in RAM or ROM mode, the version says 070626
Am I supposed to reflash or manually update the RAM and ROM mode on every build change? I do not recall reading anywhere about that.
dunno:
--- Quote from: PinkZeppelin on August 15, 2007, 02:32:09 PM ---Am I supposed to reflash or manually update the RAM and ROM mode on every build change? I do not recall reading anywhere about that.
--- End quote ---
you MUST manually reflash after every update that you do, first set boot sequence to disk, then flash to ram and then to rom.
PinkZeppelin:
I was just posting this when you replied: :D
NOTE !: With bootloader V7, prior to installing a new build in a pre-flashed player, change the default boot sequence to Disk, then Re-flash, and then restore the boot sequence to your preference
so Ill do that, im sure everything will work fine. Thanks again.
PinkZeppelin:
The version menu still freezes the player, if anyone cares.
But everything else seems to work great ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version