>Any modifications needed in software?
No, boot like in other CF modification downloaded from this forum
>And do you notice that is it slower with a SD on the iriver??
Absolutely no, quick and very responitive (quick reaction, no pause)
>:O Too bad it is a little to big (the adapter).. so it won't fit in it?
Now SC card is 5mm over upper line (jacks).
Prewiously SD is ideal in-line with jacks, but...
>Is there anyway to shorten the adapter instead of the iriver case??
I shorten it by cutting adapter board, get out 50pin
IS another chance to shorten this adapter - putting SD port on wire and glueing it somewhere on a back cover
>Any photo's.. especially with the solder flex tape into the adapter..? I don't really understand that part
Flex conducted tape - connection between H3xx MoBo and HDD.
connect SD adapter and H3xx mainboard.
Thickness of adapter board is nearly the same as space between row pins in HDD cocket in H3xx.
If I get out female 50 socket from adapter (see photo i linked above)I get 5-6mm.I can shorten board circa 3mm so I get 8-9 mm. Then I can put male pins with flex tape into board and solder it. There was unfortunately idea. Flex tape with hard board and pressing it by batterry - in effect get broke flex tape ((without radius of bonding:() past two days of use... Now I get another iRiver's flex tape, adapter 50pin>ZIF ZIF flex tape>adapter SD.
And SDHC card is over upper cover.
Now I thinking about ZIF adapter for my H3xx. ZIF >ZIF ie H3x0 zif > ATA ZIF.
>Where did you buy it
As I linked above - bouincoin.com or dealextreme.com "SD Card to ZIF/Toshiba 1.8 Adapter"
And sorry again, my English is so ...basic I can't describe It better.
Post Merge: April 02, 2012, 02:28:57 PM
Some photos http://imageshack.us/g/819/drl0455.jpg/
(more than 1000words...) but:
1) Previous version (before broke the flex HDD tape)
2) H3x0SD now
3), 4) Comparision MK6006GAH vs. new SD adapter
5), 6) inside now
7) and comparision new and shorten adapter