Rockbox Technical Forums

Installation / Removal => Manual Installation => Sandisk - Installation/Removal => Topic started by: Jmil on July 28, 2007, 05:47:44 PM

Title: i've broken my sansa e260 please help
Post by: Jmil on July 28, 2007, 05:47:44 PM

At some moment my sansa won't start and i've entered the recovery mode to install the firmware but it didn't work,so i put the i2c.bin Euro e260 and then it stopped wrote something and jammed so i left it like that till the battery run out and now it won't start,it doesn't move,nothing,PLEASE HELP ME

Title: Re: i've broken my sansa e260 please help
Post by: Llorean on July 28, 2007, 06:45:30 PM

You'll probably need to use e200tool as described here: http://daniel.haxx.se/sansa/e200tool.html

Why did you put the i2c.bin in the recovery partition? What instructions did you follow?

Title: Re: i've broken my sansa e260 please help
Post by: Jmil on July 29, 2007, 04:27:03 AM

First i've tried to install the original firmware for 2 or 3 times and it didn't work at all and the i've put the i2c.bin in the recovery partition.Now i've tried the e200tool but my computer doen't find the device.Computer doesn't say anything when i put the cable with the device in.How to do it?

Title: Re: i've broken my sansa e260 please help
Post by: Jmil on August 01, 2007, 11:00:28 AM

Could anybody say anything just to see if my matter is in good hands and you will try to solv it?

Title: Re: i've broken my sansa e260 please help
Post by: Llorean on August 01, 2007, 12:42:57 PM

You could start by actually answering both of the questions I asked you, and not ignoring forum guidelines (by double posting).

e200tool requires Linux.

Title: Re: i've broken my sansa e260 please help
Post by: Bagder on August 01, 2007, 03:30:06 PM

No description anywhere says you should put "i2c.bin" in recovery mode, and as far as I know that has no effect at all.