Welcome to the Rockbox Technical Forums!
As long as I didn't plugin both USB and DC in at the same time it should be OK right?
Question 1: Is this drawing correct? (I know I could route the wires better)
Question 2: What would the R and C values be?
Question 3: Are there better (more convenient) grounding points?
Question 4: Would any software modification be necessary or is this a 100% pure HW mod?
Question 5: Where can I purchase the worlds tiniest soldering iron?
1) get thin stranded wire
Quote from: roolku on April 06, 2007, 05:11:09 PM1) get thin stranded wireI would suggest wrap wire like this (correct me if there is a more appropriate english term for this):
R you don't need (i.e. connect to ground directly).C is to suppress spikes and should probably be as close to the IC as possible. Personally I would put it where you drew it though (or even omit it). I guess a value of 47nF would be fine.
7) carefully dip a soldering iron on the single strand above the pin hope it only connects to the one pin it is supposed to connect tobut maybe you have a better idea?
bluebrother: the link you posted didn't work for me so I have no idea what you are referring to.
As a first attempt I could forgo both the resistor and the cap?That would make this all a little bit easier.
Wish me luck!
I am totally confused with it, what the hell is going on? Any ideas or advice?
Page created in 0.073 seconds with 21 queries.