Support and General Use > Hardware
Sandisk Sansa Clip Plus: PANIC with 128gb stick but have workaround
scotty16:
I have a couple of 8gb Sansa Clip Plus, both running 3.14. I recently upgraded to a 128gb stick and a problem began. Now, as soon as I plug it into the USB port of my PC I get the following PANIC message and must do reset, by holing the power button for 20 seconds.
*PANIC*
usb_storage_init_co
nnection(): OOM
pc:300612F0 sp:300BE91
A: 3005F48C
A: 3005FA44
A: 30048C10
Luckily, I found a workaround. If the device is powered on when I connect it, then the problem does not occur and everything is normal.
Bilgus:
Most likely this is an issue of power..
I've a build with higher voltage defaults that you might try
http://forums.rockbox.org/index.php/topic,52058.0.html
__builtin:
I find this highly unlikely to be a power issue. The ipod6g had the exact same panic a while back that was solved by using static memory for the USB buffers (http://gerrit.rockbox.org/r/#/c/1361/). Perhaps a similar fix would be needed for this target.
EDIT: It seems that patch does in fact apply the same fix to the AMS devices (which includes the clip+). For some reason, it wasn't merged, though.
scotty16:
Thanks for the reply - sorry I didn't reply sooner, the notification went into junk mail. So I followed the link to a mediafire link and downloaded a zip file clipplus_powersave which contains a ".rockbox" folder. So do I just replace the one on the device ? I'm new to this so be kind. Is it worth trying even if "unlikely"?
Bilgus:
I'd say its pretty likely __builtin is right especially with the unapplied patch pretty much stating the same, I* was only suggesting a power issue because my clip+ doesn't crash with a 128 gb card and that seems to typically be the issue when problems arise
if you do want to use that build just rename your current .rockbox folder and copy the new folder to the device
Navigation
[0] Message Index
[#] Next page
Go to full version