I'm new here and have tried to make an iRiver iHP-120 into a 1TB using the parts from the first posts in this thread. When I reset the iRiver i get the stock firmware. (I think that may be normal). But when I turn the thing on with the on button i get an error -11 and it asks me to plug in a USB. Also there are two little posts inside that stick up that hold the original HDD in place. These will not allow the Ribbon Cable to seat properly. (I can hold it in place for experimentation though). What has everyone been doing with those? Cut them off?
I did flash the original unit with Pre7, then I copied the .Rockbox folder to the SSD (everything on the original, in fact). then I replaced the HDD with the SSD and this is as far as it got. What did I miss? Do I need to reinstall Rockbox on SSD?
Can some kind soul please post a step by step for the dummies out here?