Thank You for your continued support and contributions!
I just got a refurbished Sansa e260. The back of the device says its a v2, but the software info says its running software 01.
the Rockbox utility recognizes it as a v2 (unstable)
but it likes to constantly turn back on into USB mode even if I pull the battery out.
This should not happen. I'll try to reproduce this on my e200.
I'm not sure what you are trying to say here? Do you mean that it enters USB mode when you attach the USB/charger cable? That is normal operation for Rockbox. You can press the select (center) button while inserting the cable to go into "charge mode". This allows you to charge the battery while still using the e200.
Anytime I turn the device on it enters USB mode even if there is no USB cable plugged in at that time. I have had to hold in the center button every time I turn it on.
Does this happen in the original firmware too?
While in the Rockbox main menu, go to System->Debug->View I/O ports. Under GPIO STATES: in the left column, report back the value that is listed for B: with the USB cable attached to your computer and with it removed. When you attach the cable while in this screen, you do not need to press the select button since it is prevented from switching to USB mode.
I turned it on with NO USB and held select - B: FFThen I plugged in the USB and have the same - B: FF
Thanks. It still auto selects V2 even after installing Rockbox software for V1.
Page created in 0.076 seconds with 21 queries.