Thank You for your continued support and contributions!
Thanks. I'll take a look later and maybe see if there's a way to optimize that add/sub stuff. Out of interest, what fps do you get in test_fps (both at 48MHz and 192MHz)?
There's no way to get data back from the D2 to the PC... When you're dealing with 4Gb+ of data, it's quite a painful experience.
Another idea that I've been meaning to try is this: from the PC, write every sector on the UMS volume with a unique identifier based on its LBA address. Then, using the current Rockbox driver, read every sector to find which ones are read incorrectly. If we then search the NAND for the correct identifier, it might give us some clues about how the scheme really works.
Rockbox 3.0 I´m right way to get 3.0 with SVN?
compiled with the Debian4VMwareImage, the following error ocurred. But also with the 2.x build it was the same! since yesterday 3.0 i tryed again.Consoleoutput...LD rockbox.elf.../arm-elf/bin/ld: ERROR: .Dir/shrink/by/me/libgcc.a( udivsi3.o) uses FPA instructions, whereas ..D/S/By/Me/rockbox.elf does not.goes on with a lot other Errors.
"PANIC: unknown NAND: 0xEC 0xD7 0x55 0xB6 0x78"
return &all[0].info[3];
Page created in 0.086 seconds with 20 queries.